Microsoft 70-411 Exam – Q26

You have a server named Server1 that runs Windows Server 2012 R2. Server1 has two network adapters and is located in a perimeter network.

You need to install the RIP version 2 routing protocol on Server1. Which node should you use to add the RIP version 2 routing protocol? To answer, select the appropriate node in the answer area.
26a

Correct Answer:
26b

Explanation:
Enable and Configure RIP
Configure Routing Information Protocol (RIP) to enable the RRAS server to exchange routing information with other routers. By default, RIP is not enabled on an RRAS server.

To enable and configure RIP
1. In the RRAS MMC snap-in, expand IPv4, right-click General, and then click New Routing Protocol.
26c

2. Select RIP Version 2 for Internet Protocol, and then click OK. RIP now appears in the navigation pane under IPv4.
3. Right-click RIP, and then click New Interface.
4. Select the interface connected to a subnet on which the remote router is connected, and then click OK.
5. RIP is configured with default settings. If these are satisfactory, click OK to save your changes.
6. If you want to customize logging or configure the list of routers with which this server can exchange information, right-click RIP, and then click Properties.